Deluge Synthstrom - Single Cycle Waveforms

The Deluge synth can use SCWF (Single Cycle Waveforms) to create unusual oscillators.
Audio files less than 20ms are perfect.(but it can use waveforms that are longer)
The preferred format is:44.1kHz 16/24bit.WAV or AIFF up to 32bit 96kHz.
You can make these using Audacity.

Steps to load a SCWF into the Oscillator section
There are 2 ways I've found to load these:

Method 1 (short way)
1. Be in Clip/track view
2. Shift + Browse (this loads the first osc to the browser.
3.  ‘bot-toP’ will scroll on the display to
       indicate the bottom-to-top note range.
4.  Press the select button
5. scroll to your SCWF folder
6. to change the SCWF , just press the Select knob again
7. use the audition pads to play.
 

Method 2 (long way)
1. Press the Clip/track button
2. Press the Synth button
3. Shift + Type (grid button) ...
4. Press select twice... you will see OSC 1 displayed
5. press select again ...you will see type displayed
6 Press select
7. Turn select to find "SAMP". (Sample)
6. Select a sample. Navigate to ‘FiLE’
7. Press select.
8.  ‘bot-toP’ will scroll on the display to
       indicate the bottom-to-top note range.
9. press select. navigate to your SCWF folder


To enter the Waveform view
1. Shift + Start
   You should see the waveform with start and end points.
2. You can play it by pressing the Audition Keys.
3. Start = Green
    END = Red
4. Pressing each will cause it to start flashing. You can move the start and end points.
5. You can zoom in using the left/right knob (hold down & turn) to increase the resolution.

Setting the start and end loop points.
1. Hold the start line with one finger and touch the new loop point with another finger
2. Do the same for the end point
3. Start = blue
     end = purple
4. You can zoom in using the left/right knob (hold down & turn) to increase the resolution.