Tuesday, 2 May 2023

NLC Mix - build notes

Such a simple module, but so useful..
 

A 4 hp attenuverting mixer.
The pots are 0 at centre.

I've built a few of these

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 I'm using 10R resistors for the reverse voltage protection in this module, but with others I used no protection.... just a strip of wire. 
If you do accidently plug it in backwards and see the dreaded puff of smoke, the 10uF caps are the most likely component to blow.
 

100k x 8, and just one 1 k resistor

..

The op-amp is a TL-072

the pots a all linear B-100K

The pots are 0 at centre, -1x gain to the left (inverts) and
1x gain to the right. 


Thus is you are using this as a audio mixer it can be a bit tricky to find the exact centre
of the pot where its totally silent.


Pot 4 will act as a voltage offset if nothing is patched into
input 4. It can supply -5V to +5V of offset. If you do not
want any offset, leave pot 4 at midpoint, or patch your signal
into input 4.


The module will work with audio and CV signals. It is useful for creating sequences from logic modules such as the Divide and Conquer , Bools or 1/n .

Finally done.

No comments:

Post a Comment