Friday, 6 March 2020

Lyra Build - part 3

Part 3 of the Lyra 8 Build

Part 1  of the Lyra build is here
Part 2  of the Lyra build is here
Part 4: Making the Lyra Panel face plate


Building the lyra is very different from what I'm used to.

It's a bit like soldering an SMD board with through hole parts.
The pots and switches  are wired to pads, .... not into holes in the PCB as you would usually see if you were building a Eurorack module.

The separation of the synth into a control pcb & the main PCB should make trouble shooting easier. I first started connecting the pots to the PCB with left over resistor wire, but in hindsight, insulated wire would be better. ... less chance of shorts.



Lots of cleaning up to do post soldering.
This is the keyboard.


Closeup of the rear of the keyboard section.


Connecting the upper and lower boards.

I'm using insulated ribbon cable and making my own headers.

Make nine 12 pin ribbon cables.
and one 5 pin cable (for the in-out board.

 Lot's and lots of wire stripping. :-)

There are 3 boards to connect ... don't forget the in - out board.

This connects in two spots . One to the main  board, and another to the control / pot board.




tHE shields



tIME TO plug everything in



tHE in/out board connects to your DC power source






tHE case is a bit rough ... just some recycled timber.

will need to tidy up after its fully tested.



Part 1  of the Lyra build is here
Part 2  of the Lyra build is here
Part 4: Making the Lyra Panel face plate

5 comments:

  1. What size ribbon cables did you use?

    ReplyDelete
  2. Hi there, very interesting. Do you have an idea of what you spent on top of purchasing the kit? Thanks

    ReplyDelete