sTART WITH the lowest profile components ..
usually IC sockets , resistors , etc
These are personal build notes just to help me trouble shoot should I have any probs.
As it turned out, this was a easy build.
cAPS next
the BOM calls for these:
0.002uf 1 Poly box type. ... 2nf or 2000pF
I'm using a 2.2nF cap
0.02uf 1 Poly box type ...20nF or 20000pF
I'm usinh a 22nF cap instead
.01uf 7 cheap ceramic disk....10nF (103)
sWITCHES next ... not sure how the panel and PCB link ??
i decided to install the jacks , switches first.. Then it became apparent the the panel is held to the PCB by the pots.
Solder the pots to the PCB.
Time for the sole LED
Jacks:
IN - tip of the input jack
CV - tip of the CV jack
OUT - tip of the output jack and switch of the CV jack to allow self modulation
Modulation Waveform Selection switch:
MS - Top lug of switch
MC - Center lug of switch
MT - Bottom lug of switch
Output Waveform Selection Switch:
OS - Top lug of switch
OC - Center lug of switch
OT - Bottom lug of switch
For a ground connection, use the center wirepad of whichever power supply you're not using.
Nice !!!
Links
Manual BOM Build notes
http://www.bartonmusicalcircuits.com/fmd/
-----------------------------------------------------------------------------------------------
For more Euro DIY builds click here:
http://djjondent.blogspot.com.au/2017/12/diy-index.html
-------------------------------------------------------------------------------------------------
No comments:
Post a Comment