These are my build notes for the CLUMP module.
\
Its a 4x4 CV controlled matrix mixer
This means there are 16 VCAs on-board along with 4 mixers.
Each VCA gets a 1k trimpot to remove any offset voltages,
each input gets a switch to
turn off or invert the incoming signal and the pots act as gain pots
with no CV patched in and as attenuators when CV is patched.
Its DIY
Links
+ Wiki
+ BOM
I'm using these Transconductance Amplifiers
Mouser Part No
926-LM13700M/NOPB
926-LM13700M/NOPB
TL072 x 10
LM13700 x 8
16 trimpots
1K OHM TRIMMER POTENTIOMETER
purchased ebay
yes - arrived.
code is 102
Getting as many caps and resistors on while I wait parts to arrive.
-----------------------------------------------------------------------------------
You can find more NLC builds here.
--------------------------------------------------------------------------------------
No comments:
Post a Comment