Sunday, 16 February 2020

Precise looping 2 - using a recorded internal kit loop

This is one way of sampling loops to a selected BPM
This uses the deluges own internal kit or synth engine
In the Guide Book (3p0) it's it's under " Creating an Audio Clip in Song View" (p133)

1. Song view
2. press any pad 1 - 16 in a row
3. use kit view
4. set a 4 x 4 drum loop
5. select your tempo
6. press song
7. in the row below
    a. press 1-16 + select
    b. LEARN + 1-16 --  mix
    c. hit select
8. Rec + Launch (2nd row) -- check arm status
    Flashing purple or red is OK
9. press REC
10. Press play

11. Press Launch to stop


The recorded clip will set the tempo of your future loop samples.

In step 7.    I used the MIX option. I could also have used the oUTP setting.
Other options are:
      Off (oFF)
      Left / Left (dot)
      Right/ Right (dot)
      Stereo (StEr) / Stero (dot)
      Balanced (bALA) / bALA (dot)
      Mix -- sources audio from the deluge's output.
                  There is no FX (pre FX) or level adjustment
                   Use this for "bouncing" everything to a single clip.
                   This is different from the Deluge's resampling option
                   which can be used for recording the final output.
      Output (oUTP) -- sources audio from the deluge's output.
                                    Similar to MIX, but this is post FX.
                                    It's the same as resampling.
---------------------------------

Loop recording is not to be confused with resampling which just writes your recordings to the SD card in the folder:
SAMPLES / RESAMPLING
----------------------------------------------

I'm still new with the version 3 firmware so do let me know if there are any mistakes, omissions or errors.

No comments:

Post a Comment